This document will show you how to use the app to find out the status of Marty's Wi-Fi connection and connect your Marty to a Wi-Fi network.
Connecting Marty to your Wi-Fi will let you program Marty in Python.
There are a few important things to note:
A white LED shows when Marty is connected to Wi-Fi, and Bluetooth is disconnected. If you then reconnect to Bluetooth, the light will turn blue.
You can configure Marty's Wi-Fi connection using the Robotical App, available on the web and mobile devices.
Connect to your Marty as normal and click on Robot settings in the bottom left.
The configuration screen will show the status of the Wi-Fi connection. Click Connect to proceed.
You will see a list of Wi-Fi networks or the app may recognise the Wi-Fi you are connected to. Select the network you wish to connect to, and click “Continue”.
Enter the Wi-Fi network password and select “Continue”.
You will see a message that Marty is connecting to your Wi-Fi network. Press complete setup to finish the setup.
On successful connection
When the connection is made, Marty will then temporarily pause Wi-Fi until you disconnect from Bluetooth.
If the connection is unsuccessful
If Marty can't connect, you'll see this screen after about 30 seconds. Please try again, and check:
If the problem persists, contact our support team at support@robotical.io.
Once Marty is connected to Wi-Fi, you can find his IP address in the Robotical App's connection settings.
An IP address identifies Marty on your local network and usually looks something like 192.168.1.135.
You'll need this address when connecting to Marty over Wi-Fi using Python.
Take note of your IP address and disconnect your Marty from Bluetooth using the disconnect button on the main page of the mobile app.
It is important that the connectivity LED on the back of your Marty is white. If it is blue that means your Marty is still connected to Bluetooth and won't be available over Wi-Fi.
If your Marty is displaying a solid white LED that means you are good to go.